Care And Maintenance - Aquaglide Rockit Owner's Manual

9) There are 2 boarding areas on the Rockit. To board, approach the boarding
area and tip the Rockit toward the user with the lowest boarding handle. Climb
using the handles and foot step provided. Generally it is best to allow the
heaviest and/or strongest group member to board first. Once on board, group
members should make sure to keep the Rockit tipped toward the boarding area,
allowing remaining group members to board and assisting where necessary.
Rockit Diagram

Care and Maintenance

Perimeter Tube
Saddle Valve
1) While your product has been initially treated with UV protectant, long-term
Valve
exposure to sunlight will damage the product. Regularly apply a UV protectant
to the exposed surface of the tube to ensure the life of your product. We recom-
mend using ONLY 303 UV Protectant intended for use on vinyl for this purpose.
Monthly application while the product is in use is required.
NOT DOING THIS WILL VOID THE WARRANTY. 303
UV Protectant is available at most watersports dealers,
or online at www.303-products.com.
2) WARNING: Certain products, especially petrolium-
based solvents, cleaners and protectants such as
ArmorAll can damage the product and use of these
products will void the warranty.
3) WARNING: Use of a high-pressure washer will damage the
product and void the warranty. To clean, use a soft bristle brush
with mild soap and fresh water. 303 UV Protectant contains a 'safe
for vinyl' cleaner, and can be used to clean and protect the product at
the same time.
Boarding Area
4) Check the inflation of your tube often. Check for proper air pressure using a
manometer. It may appear to have lost air early in the morning, but will expand
once the sun warms it. Maximum expansion will occur in the heat of the day.
Proper inflation is critical to the safe operation of your product and will prolong
damage from wear.
Anchor Rings
Storage
Main Valve
1) Before storing, place the product on a clean, level area. Clean with mild
soap and water and allow to dry completely. Apply 303 Protectant to all
surfaces of the Rockit before deflating.
2) Remove all attachments and store in a sealed water-proof container (i.e. a
plastic covered box or bin).
3) Remove ALL of the air from the tube using the deflation end of the high
output inflator/deflator. If some air is left in the tube, it may freeze causing
cracking.
4) Fold the deflated tube in thirds then roll loosely.
5) Store the product out of direct sunlight and protected from the environment
in a clean, dry location. It is best to store inside a container with moth balls to
prevent damage from rodents. NEVER store uncovered, in a damp location, or
on a concrete surface! NEVER store at temperatures below 40 degrees F.
www.Aquaglide.net
Aquaglide, Inc. #1 North Shore Dr, SE White Salmon, WA 98672 TEL: (509) 493-4938 FAX: (509) 493-4966