Care And Maintenance - Aquaglide i-LOG Owner's Manual

Aquaglide, Inc. #1 North Shore Dr, SE White Salmon, WA 98672
Operation
1) This item is a balance beam for water use. Users attempt to maintain balance in
sitting, kneeling or standing position while moving along the item. *This item
is not designed for independent use. Use ONLY when attached to a properly
anchored Aquaglide Platinum main feature item.
2) When connecting multiple items, use only Aquaglide Interloc™ straps and con-
necting rings according to the Interloc™ Strap instructions provided. Make sure that
the connection is tight and that there is NO GAP greater than 25mm (~3/4") between
items. IMPORTANT: Failure to connect these items properly may result in injury
or death.
3) Place the i-LOG™ in at least 4 ft.(1,2m) of water depth and in an area protected
from the wind and boat traffic. Review your lake rules and restrictions with your
local authorities.
4) Carefully check area under the i-LOG™ for sharp or dangerous objects (i.e. rocks
or stumps).
5) Keep a safe distance of 15 ft. (4,5m) away from docks, boats, boat lifts, and any
other structures. DO NOT tie the i-LOG™ to a dock! Do Not use the i-LOG™
except when attached to an Aquaglide® Supertramp™ or Rebound™.

Care and Maintenance

1) While your product has been initially treated with UV protectant, long-term
exposure to sunlight will damage the product. Regularly apply a UV protectant to
the exposed surface of the tube to ensure the life of your product. We recom-
mend using ONLY INDIKON POLY GUARD UV for this purpose. Seasonal
application while the product is in use is required. NOT DOING THIS WILL
VOID THE WARRANTY. POLY GUARD UV is available at most watersports
dealers, or online at http://www.aquaglide.com/product-category/accessories/
maintenance/.
2) WARNING: Certain products, especially petrolium-based solvents, cleaners
and protectants such as ArmorAll can damage the product and use of these
products will void the warranty.
3) WARNING: Use of a high-pressure washer will damage the product and void
the warranty. To clean, use a soft bristle brush with mild soap and fresh water.
INDIKON MAXI CLEAN can be used to thoroughly clean the product before stor-
age.
4) Check the inflation of your tube often. Check for proper air pressure using a
manometer. It may appear to have lost air early in the morning, but will expand
once the sun warms it. Maximum expansion will occur in the heat of the day.
Under-inflation can cause excessive rubbing where the i-Log attaches to the
bouncer. Proper inflation is important as this will discourage rodents from chewing
and prevent damage from wear.
Storage
1) Before storing, place the i-LOG™ on a clean, level area. Clean with mild soap
and water and allow to dry completely. Apply POLY GUARD UV to the surface of
the i-Log before deflating.
2) Remove ALL of the air from the tube using the deflation end of the high output
inflator/deflator. If some air is left in the tube, it may freeze causing cracking.
3) Store the i-LOG™ out of direct sunlight and protected from the environment in a
clean, dry location. It is best to store inside a container with moth balls to prevent
damage from rodents. NEVER store uncovered, in a damp location, or on a
concrete surface! NEVER store at temperatures below 40 degrees F.
TEL: (509) 493-4938 FAX: (509) 493-4966
For more information go to:
www.Aquaglide.com