Product Setup - D-Link DCS-6004L Quick Installation Manual

PRODUCT SETUP

WINDOWS USER
4
Step 1:
Remove the camera housing by squeezing the housing release
buttons on both sides of the came
Step 2:
Connect the included Ethernet cable to the network cable connector
located inside of the camera and attach it to the network.
Step 3:
If you are going to power the device using Power over Ethernet, you
can skip this step and continue with the configuration of the device.
Otherwise, attach the external power supply to the DC power input
connector located on the inside of the camera and connect it to your
wall outlet or power strip. Power is confirmed when the green LED
Power Indicator is lit.
Step 4:
Reattach the camera housing by lining up the housing so that the
access port on the housing matches the access port on the camera
base. Firmly push down until the camera housing snaps back onto
the camera base.
Step 5:
Insert the Network Camera Driver CD in the CD-ROM drive. If the
CD Autorun function does not automatically start on your computer,
go to Start > Run. In the run box type D:\autorun.exe (where D:
represents the drive letter of your CD-ROM drive) and click OK.
When the autorun screen appears, click Set up your Cloud Camera
and follow the on-screen instructions.
Step 6:
Click on the Start button to start the wizard, and follow the
instructions from the Installation Wizard to finish setting up your
camera.
DCS-6004L / DCS-6005L