Table of Contents
Advertisement
2-1-8. Assembly Procedure of Printer Mechanism
Sot paper guido (B) (3-2).
Install rubber roller shaft (3-3) Into the right side plate of the
frame unit by using tho eoncave of the arrow section.
0)
Set the wire, as shown in Fig. below. Into the pulley
mounting stand unit and the pullay installed on the lelt
edge of the frame unit.
Fig. A
(a)
Install release lever (5-10). release lever spring, clutch
stopper and E washer (EW2.5) m that order.
Bring down the release level (5-10) to the rear.
Set the carnage guide plate (2-1-13) from the left side of
the frame unit (I - I | and perform setting by drawing the right
side section to the left.
insert pulley mounting stand unit (2-3) from above.
Install oullev gear unit (2-1-17).
Remove wire holding jig from the pulley gear unit (2-1-17).
Engage the teeth of the pullay gear (non-becMosh goer)
after shifting 2 teeth.
Slide the rubber shaft (3*3) to the left-
At this point, the protruding section of the clutch stopper is
Inserted into the slot of the clutch.
Slide Ihe besting (3-6) to the right end suppress it into the
right side plate of the frame unit.
Inatall fastening spring (3-4) In the position ae shown m Fig.
A
Install screws on both sides of tho paper guide (B) (3-2).
Insert rubber roller goer (3-14).
Attach insulting screw (2-9) to the platen.
@
Install stepping motor (4-1), set the motor side piste unit (I)
|4-2) and secure with 2 screws each.
Install idle gear (4-4).
0
Install romforecmont plate (4-5).
;7i)
Install 2 E washers (EWt.5).
Install hoed pressure contact spring (2-8) on tho loft and
right.
PRN-T24(AE|
2-5
Advertisement
Table of Contents
