Table of Contents
Advertisement
INSTALLATION & STACKING INSTRUCTIONS (if applicable)
Other than the optional legs, this unit is ready for operation after uncrating. In the event that you ordered a "double-
stack" of two Dual Technology Finishers, stacking brackets will be required to properly anchor the equipment
together. When stacking appliances, it is required that two stacking brackets be properly attached to the units to
ensure a proper fit and connection.
!
WARNING:
DTF STACKING BRACKET
Part Number: 7008811
Location of Stacking Brackets (shown
on front of oven in this case).
DTF – 1960 Series Operator Manual
Two stacking brackets must be used when stacking two DTF units together. A
maximum of two units may be stacked together.
Stacking Brackets have been designed to align with
the screw openings for the DTF covers (upper and
lower). Two brackets are required for each set of
appliances and may be placed either on the front or
back of the appliances.
Utilize the following instructions to properly stack the
DTF units together.
1. Turn each unit off and unplug each unit from its
power source.
2. Remove the two screws from the "Unit Top" of the
bottom appliance.
3. Remove the legs from the top appliance. Remove
the two screws from the "Unit Bottom" of the top
appliance.
4. Gently lower the top unit onto the bottom unit
making sure to align the screw holes of the "Unit
Top" and "Unit Bottom."
5. Once the appliances have been aligned, align the
holes in the Stacking Bracket to the holes in the
top and bottom DTF appliances. Reinsert the
screws so that the Stacking Bracket connects the
top and bottom units together. Repeat this step
with the second Stacking Bracket. The DTF units
are now properly stacked.
6. Plug each unit into its appropriate power source
and turn on to begin operation.
5
Advertisement
Table of Contents
