Tv Installation; One Invisible Connection Guide; Class 1 Laser Product - Samsung Q9F Series User Manual

01 TV Installation
One Invisible Connection Guide
D
ONE CONNECT
TV
To connect the One Invisible Connection to the One Connect and your TV, follow these steps:
1. After the TV is completely set up and placed in its final position, connect the thicker connector of the One Invisible
Connection to the TV, and then connect the thinner connector to the One Connect as shown in Steps 1 to 4 above.
WARNING: Make sure that both connectors are fully and firmly connected. If either connecter is not connected
properly, there is a danger of severe electric shock.
2. Connect the One Connect AC power cord to the One Connect, and then connect the cord to a wall outlet as shown
in Step 5 above.
WARNING: Follow the directions exactly. Be sure to connect the power cord to the wall outlet as the last step.
Always disconnect the power cord from the wall outlet before disconnecting the One Invisible Connection from
the back of the TV or from the One Connect.
- See the illustrated Quick Setup Guide for more information.
~-
When connecting the One Invisible Connection, use a Bending Cover, which prevents the cable of the
One Invisible Connection from being bent at a 90 degree angle, to bend the cable. Failure to do so may
cause damage to the cable.
• When connecting the One Invisible Connection, pay attention to the shapes and sizes of its connectors so
that they are connected correctly. Failure to do so may cause product malfunction.
• When connecting the One Invisible Connection, be careful not to twist the cable of the One Invisible
Connection. Failure to do so may cause performance degradation of the TV or damage to the cable.
• When arranging the remaining cable, refer to the figure above for the correct arrangement.
• Take care not to subject the cable to any of the actions below. The One Invisible Connection contains a
power circuit. You could damage the cable and subject yourself to an electric shock.
• Handle the One Connect box carefully. It is heavy.
M\
\£:1
Bending
CLASS 1 LASER PRODUCT
Twisting Pulling Pressing on
• Caution- Invisible laser radiation when open. Do not stare into beam.
- Do not bend the One Invisible Connection cable excessively. Do not cut the cable.
- Do not place heavy objects on the cable.
- Do not disassemble either of the cable connectors.
Electric shock
• Caution- Use of controls, adjustments, or the performance of procedures other than those specified
herein may result in hazardous radiation exposure.
3. Connect your peripherals (antenna, cable box, Blu-ray player, etc.) to the One Connect box. See the Accessories Kit
Guide for details.
English -7