Table of Contents
Advertisement
Controls and Functions
1.
Power Connector
A DC adaptor can be used when the USB port cannot provide
enough power to the unit. Please use only a 6V DC adaptor.
2.
ON/OFF Switch
Turns the DJC.4 ON/OFF.
3.
USB Port
Connects your DJC.4 to your computer for both audio and
power.
Note: maximum USB cable length is 3 meters.
4.
Balanced TRS Master Output Jack
For connection to a professional amplifier or mixing console
with a balanced input.
5.
Master Output (RCA) Jack
For connection to a consumer-level speaker system.
6.
PH/LN Input Jack
These jacks are inputs for a phono (RIAA) stage for
magnetic (MM) cartridge or a line level device.
7.
PH/LN Selector Switch
These switches are used to change the voltage line levels
of the respected PHONO/LINE RCA inputs jacks. When
connecting turntables with magnetic cartridges to these
jacks be sure the corresponding switch is in the "PHONO"
position, and when using line level input devices be sure the
switch is in the "LINE" position.
8.
GND(Ground Terminal)
For turntable connection. Always use this connection when
using standard turntables with ground cable.
9.
PH/THRU Switch
Send the AUX or LN/PH 1 signals directly to the master out
and disconnects the computer output.
Select the AUX or LN/PH1 from the Input 1
selection.
10. AUX IN
CD players, MP3 Player, Tablet Pad and other line level
instruments may only be connected to this jack. Input
volume will be controlled by the channel fader. The channel
SOURCE SELECTOR SWITCH must be in the "AUX".
11. Input Gain
These knobs are used to adjust the audio source signal input
gain for a channel. Never use the gain control to adjust a
channel output volume, as this can lead to distortion.
Advertisement
Table of Contents
