Philips Semiconductors
5.2.
Preparing for Software Installation
Create a directory called "C:\philipsMpeg\"
to this directory.
•
•
•
Copy files in directory "
application software searches initial files under directory C:\philipsMpeg and, therefore,
whenever the device is initialized, the application prompts for the current path of the file.
Note: Copy file MSVCRTD.DLL from the Application directory to the WINNT\System32\
directory, if the file is not present on your PC.
5.2.1. Installing the Device Driver
Connect the device to the system. When the system prompts for the INF file, redirect the
system to the C:\philipsMpeg\Driver directory and load the driver by using the INF file.
5.2.2. Installing the Decoder
To install the supplied decoder, run the "register.bat" DOS batch file. This file can be found in
directory C:\philipsMpeg\Decoder. The decoder consists of eight software components.
The contents of the register.bat batch file are:
•
•
•
•
•
•
•
•
1
It is strictly recommended to name the directory as philipsMpeg and must be located under the C drive.
User manual
Application\
<drive>:\
Driver\
<drive>:\
Decoder\
<drive>:\
<drive>:\
regsvr32 pim2null.ax
regsvr32 mpgdec.ax
regsvr32 mpeg2dmx.ax
regsvr32 pva_dmx.ax
regsvr32 mlcom.ax
regsvr32 windivx.ax
regsvr32 ball.ax
regsvr32 mpg2splt.ax.
Rev. 03.00 — 12 April 2004
ISP1581 Hi-Speed USB MPEG2 Encoder Reference Kit
1
, and move the following three unzipped directories
InitFiles\*.*" to directory "C:\philipsMpeg". By default, the
UM10016_3
© Koninklijke Philips Electronics N.V. 2004. All rights reserved.
8 of 28