Table of Contents
Advertisement
S e t u p
R-UIM Setup
When you subscribe a network, you are provided the
CHV code, which is a password for use of the UIM
card. Using this menu, you can enable the CHV code
to avoid using the card by the unauthorized user.
Also, you can change the code as you want.
The following options are available:
Enable CHV: activates use of the CHV code. With
the code enabled, you must enter your
CHV code each time you switch the
phone on. Consequently, any person
who does not have the code cannot
use your card without your approval.
Disable CHV: deactivates use of the CHV code. Any
person can access the data in your
UIM card.
Change CHV: allows you to change the CHV code as
your preference. Enter a new code up
to 8 digits. Then, enter the new code
again when prompted for
confirmation.
120
Menu 9-0
Reference Information
Using the Batteries
Your phone is powered by a re c h a rgeable Li-ion
s t a n d a rd battery.
Precautions When Using Batteries
• Never use any battery that is damaged
in any way.
• Use the battery only for its intended purpose.
• If you use the phone near the network's base
station, it uses less power; talk and standby times
are greatly affected by the signal strength on the
cellular network and the parameters set by the
network operator.
• Battery charging times depend on the remaining
battery charge and the type of battery used.
The battery can be charged and discharged
hundreds of times, but it will gradually wear out.
When the operation time (talk time and standby
time) is noticeably shorter than normal, it is time
to buy a new battery.
• If left unused, a fully charged battery will
discharge itself over time.
121
Advertisement
Table of Contents
