Table of Contents
Advertisement
Getting Started
WARNING!
Do not switch on the phone when the mobile
phone use is prohibited or when it may cause
interference or danger.
Note: Do not touch the antenna on the phone
unnecessarily when the phone is switched on.
Contact with the antenna affects call quality and
may cause the phone to operate at a higher power
level than otherwise needed.
Changing the Display for Standby
Mode
Your phone provides you with a variety of items to
display in Standby mode. You can change the idle
screen with ease to one of the following items
depending on your preference.
• Clock and calendar: displays a clock with a daily
pad calendar. This is default display.
• World clock: displays two clocks showing the time
in the time zones selected in the World Time
menu option (see page xx).
• Digital clock: displays the digital clock.
• Wallpaper 1 and 2: displays the wallpaper
animations selected in Idle 1 and Idle 2 under the
Animation menu option (see page xx)
respectively.
To change the display in Standby mode, press down
navigation key repeatedly until you find the desired
display.
22
CHV Code
The CHV code supplied with the UIM card helps you
protect the UIM card against unauthorized use.
When requested the code, key in the appropriate
code (displayed as asterisks for security). If you enter
an incorrect CHV code three times in succession,
your UIM card is blocked. To unblock the card,
contact your service provider.
You can enable or disable the code using the R-UIM
Setup menu option (9-0). For further information on
the CHV code, see page xx.
Your Phone's Mode
Standby Mode
Standby is the most basic state of your phone. The
phone goes into Standby mode soon after you turn it
on, or whenever you briefly press
phone is in Standby mode, you will typically see the
current date and time. If you enter a phone number,
you can press
to dial it, or press
in the internal phone book.
Press
at any time to return to Standby mode. Be
careful; if you are on a call when you press
will return to Standby mode, but it also disconnects
the call. Press
several times or hold it down to
return to Standby mode without ending the call.
Getting Started
. When your
to save it
, you
23
Advertisement
Table of Contents
