Electrolux ENN2801EOV User Manual page 13

Problem
Water flows on the floor.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
7.2 Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The "FastFreeze mode"
is switched on.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
The "FastFreeze mode"
is switched on.
There is no cold air circu‐
lation in the appliance.
7.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
3. If necessary, replace the defective
Solution
Attach the melting water out‐
let to the evaporative tray.
Switch off "FastFreeze
mode" manually, or wait until
the mode resets automatical‐
ly to set the temperature.
Refer to "FastFreeze mode".
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces‐
sary.
Refer to "FastFreeze mode".
Make sure that there is cold
air circulation in the appli‐
ance.
to assembly instructions.
door gaskets. Contact the Authorised
Service Centre.
ENGLISH 13