User Safety - Plott Cubit User Manual

USER SAFETY

WARNING:
Carefully read the Safety Instructions and Product Manual before using this product. The person responsible for
the instrument must ensure that all users understand and adhere to these instructions.
WARNING:
The following label information is placed on your laser tool to inform you of the laser class for your convenience
and safety.
The CUBIT Products emit a visible laser beam as shown in Figure A. The laser beam emitted is Laser Class 2 per
IEC 60825-1 and complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to Laser Notice No. 50,
dated June 24, 2007
WARNING:
While the laser tool is in operation, be careful not to expose your eyes to the emitting laser beam (red light
source). Exposure to a laser beam for an extended time may be hazardous to your eyes. Do not look into the beam
with optical aids.
Caution
This device complies with Part 15 of the FCC Rules / Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures: