Advertisement
Installation - tap
Before installing your new mixer, flush
through the pipework to ensure removal
of debris, turn off the water supply.
Place the mixer in position.
From the underside slide the metal
washer and then the rubber washer over
the threaded connection and screw into
the back hole of the mixer. Tighten the
nut to clamp the mixer to the unit.
CAUTION: Do not over tighten the nut
as this may damage the unit.
Screw the flexible pipes to the mixer.
Connect the water supply to the
inlet pipes. The hot water should be
connected to the left hand pipe and
cold to the right.
Connect the back outlet pipe to the
diverter using a flexible pipe.
4
Control
handle
Rubber
washer
Metal
washer
Nut
Threaded
connection
Outlet
Flexible
pipe to the
diverter
Cold inlet
Hot inlet
Installation - diverter valve
Screw the nut onto the valve body,
slide on the metal washer and rubber
washer, push the valve up through the
hole in the unit.
Slide the cover ring over the valve
making sure that the seal is in place on
the underside. Screw the cover onto the
valve. From the underside tighten the
nut to secure the valve in place.
CAUTION: Do not over tighten the nut
as this might damage the unit.
Carefully push the control handle onto
the splines of the valve and secure
using the hexagonal screw, replace the
screw cover.
Connect the valve to the tap, spout and
handset using the flexible connectors.
Hexagonal
screw
Control
handle
Cover
Cover
Cover ring
Rubber
washer
Metal
washer
Nut
Valve
Flexible pipe
inlet from
tap
Flexible pipe
Flexible pipe
outlet to
outlet to
spout
handset
plug
5
Advertisement
