VADO life Installation & Maintenance Instructions page 3

Installation - shower (and optional spout)
Hand set
Base
ring
Base
shroud
Connecting
tube
Shower
hose
Rubber Washer
washer
Washer
Shower
Nut
hose
Flexible pipe
Remove the nut, washer and rubber
washer from the connecting tube. Push
the shower hose and connecting tube
down through the hole, make sure the
seal is in position in the bottom of the
base shroud. From the underside slide
on the rubber washer, metal washer and
then the nut. Tighten the nut to clamp on
the cover plate.
CAUTION: Do not over tighten the nut.
Place a rubber washer into the nut end
of the shower hose and screw onto the
flexible pipe coming from the diverter.
Place the rubber washer into the cone
end of the hose and screw to the handset.
6
Spout
Rubber
washer
Nut
Flexible pipe
Position the spout in place , and from the
underside slide on the rubber washer,
and then the washer/nut. Tighten the
nut to clamp on the spout.
CAUTION: Do not over tighten the nut.
Connect the spout to the diverter using
the large flexible pipe.
Dimensions
45mm
48mm
Operating Specifications
Operating Pressure:
Minimum operating pressure 3 bar
Maximum operating pressure 5 bar
55mm
42mm
55mm
3