Sharp XL-MP130 Operation Manual page 27

Memorizing a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
1
Perform steps 1 - 3 in "Tuning" on page 26.
2
Press the MEMORY/SET (MEMORY) button to enter the
preset tuning saving mode.
3
Within 30 seconds, press the PRESET (
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4
Within 30 seconds, press the MEMORY/SET (MEMORY)
button to store that station in memory.
If the "MEMORY" and preset number indicators go out before
the station is memorized, repeat the operation from step 2.
5
Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorized for that preset channel number will be erased.
Note:
The backup function protects the memorized stations for a few
hours should there be a power failure or the AC power cord become
disconnected.
To recall a memorized station
Press the PRESET (
lect the desired station.
To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
1 Press the PRESET (
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET (
tion is located.
or ) button to
To erase entire preset memory
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 While pressing down the
press the TUNING
or ) button for less than 0.5 seconds to se-
or ) button for more than 0.5 seconds.
or ) button again when the desired sta-
PRESET
button and the X-BASS button,
button until "TUNER CL" appears.
XL-MP130
27