Maintenance And Cleaning; Maintenance Plan - Stiga SWP 475 Operator's Manual

Maintenance and cleaning
9. M aintenance and cleaning
WARNING WARNING
Risk of cutting due to broken glass, metal Risk of cutting due to broken glass, metal
or other sharp edged materials! or other sharp edged materials!
When emptying the sweeping container, When emptying the sweeping container,
cutting injuries may occur due to broken glass, cutting injuries may occur due to broken glass,
metal or other sharp edged materials. metal or other sharp edged materials.
• Wear the prescribed personal protective • Wear the prescribed personal protective
equipment! equipment!
CAUTION
Health impairments caused by dust Health impairments caused by dust
resulting from sweeping! resulting from sweeping!
The inhalation of dusts can endanger the The inhalation of dusts can endanger the
EN
health. health.
• Wear the prescribed personal protective • Wear the prescribed personal protective
equipment!
equipment!
CAUTION CAUTION
Risk of injury through tipping over of the Risk of injury through tipping over of the
sliding bracket! sliding bracket!
Tipping over of the sliding bracket may lead to Tipping over of the sliding bracket may lead to
slight injuries, such as jamming of the fi nger or slight injuries, such as jamming of the fi nger or
haematomas in users or other persons. haematomas in users or other persons.
• When carrying the device, hold it so that the • When carrying the device, hold it so that the
sliding bracket cannot tip over. sliding bracket cannot tip over.
CAUTION CAUTION
Hazard due to cleaning materials! Hazard due to cleaning materials!
The agents can contain harmful ingredients The agents can contain harmful ingredients
and can thereby cause irritation of the and can thereby cause irritation of the
respiratory tract and the skin. respiratory tract and the skin.
• Observe the manufacturer's safety data • Observe the manufacturer's safety data
sheet. sheet.
• Avoid spillage and the formation of fog. • Avoid spillage and the formation of fog.
• Do not eat, drink or smoke while working. • Do not eat, drink or smoke while working.
• Avoid contact with skin and eyes. • Avoid contact with skin and eyes.
70
SWP 475 / 577
In the following sections the maintenance and
cleaning work required for optimal and fault-free
operation is described.
The conduct of the specifi ed work depends
in some cases on time and/or load. For the
maintenance interval information shown both in
deadlines and service hours, the one that occurs
fi rst applies.
In case of questions on the maintenance work
and intervals contact the manufacturer.
9.1 Maintenance plan
Maintenance Maintenance work
interval
Before Check the device to make sure that it
starting is functioning before starting work. If
necessary, contact the Service.
work
Check the sliding bracket to make sure that
it is fi rmly fi xed in the handle fi ttings.
Check the sweeping container to make sure
it is fi rmly fi xed and in good condition.
Check the plate brooms and the fi ne dust
sweeping roller for rolled up threads and
cords. Remove these if necessary.
Check the plate brooms and the fi ne dust
sweeping roller for jammed items or contami-
nation.
Check the handles for contamination and
clean if necessary.
Check that the height adjustment is at the
correct height.
Check the sweeping pressure setting. Adapt
the sweeping pressure to the surface to be
swept, if necessary.
After fi nishing Empty the sweeping container.
work
Clean the device.
8 Bh Clean broom drives.