kim lighting Bell EL 160 Installation Instructions

Accent / Pathlighter Installation Instructions
Bell
™
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
WARNING: Fixtures must be grounded in accordance with local codes or the National Electrical Code.
!
Portable spear or tree mounts using a cord and plug, must be plugged into a receptacle protected by a
Ground Fault Circuit Interrupter (GFCI) in accordance with the National Electrical Code. Failure to take these steps
may result in serious personal injury. Lighted lamp is HOT! Do Not touch hot lens, guard, or enclosure.
MAINTENANCE: To maintain light efficiency and prevent fixture overheating, lenses must be kept clean and free
of dirt, dust, leaves, trash and mineral deposits from water. For optimum performance a regularly scheduled
maintenance program should be followed. DO NOT operate luminaire with missing or damaged lens.
CAUTION: L.E.D. fixtures are available in 120 volt input or 277 volt input. Please verify before wiring fixture to
field wires (see lamp label to verify). KEEP THIS SHEET FOR FUTURE REFERENCE.
Tools Required:
Flat Blade Screwdriver
Installation Instructions:
1. Run wires through pole and thread
short thread into pole cap.
IMPORTANT!
For L.E.D. fixtures
only, verify input
voltage . See
CAUTION above.
4. Make all necessary connections
observing polarity, i.e. green-to-
ground, white-to-common, and
black-to-voltage.
Reviised 7/16/10 ECN 100715008
P.O. Box 60080 • 16555 East Gale Ave.
City of Industry, California 91716-0080
626/968-5666 • FAX 626/330-3861
IMPORTANT SAFETY INSTRUCTIONS!
3 /32" Allen Wrench
!
Make certain the electrical supply is OFF before starting fixture installation.
2. Coat threads with a good sealant
and install pole into desired
junction box. (Direct burial box for
H.I.D.)
5. Remove screws from lens frame
with a flat blade screwdriver.
Status 9
Adjustable Wrench
3. Position fixture & tighten locknut
with adjustable wrench.
Par 20
Lamp
6. Install lamp of type and wattage
shown on fixture label & chart.
Do not exceed maximum watt-
age. Re-install lens and lens
frame. (EL167, BN167 shown on
page 2.)
EL160
BN165
6160
EL167
6165
BN167
Thread Sealant
Part No. 95617