Compliance Declarations - Delta Controls RTS-424 Installation Manual

Room Temperature Sensor RTS-424 (Rev 4.2) Installation & Application Guide
Cautions and Warnings
The RTS-424 is an Electro-statically sensitive device. However, since the electronics are
contained within the housing, and if sufficient care is taken in handling, proper ESD protection
WARNING
(ground strap) should be unnecessary.

Compliance Declarations

FCC Compliance Information
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference at his
own expense.
Industry Canada Compliance Statement
ICES-003 This Class B digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la Classe B Respecte toutes les exigences du Règlement sur le matérial
brouiller du Canada.
UL Compliance Information
This product conforms to the following UL requirements:
• UL916: Energy Management Equipment
• CAUTION – Risk of Electric Shock – More than one disconnect switch may be
required to de-energize the equipment before servicing
• All terminals are acceptable for Class 2 circuit connection only
• CAUTION – Input Class 2 Power Supplies are interconnected. To Reduce the Risk of
Fire or Electric Shock, Use only Class 2 sources Suitable for Interconnection
• Use Copper Conductor Only
• Select an external power supply that is certified for safety for the correct destination
country and that has an output rating, which is considered an NEC Class 2 or Limited
Power Source with the rating not to exceed 30 V rms, 42.4 V peak, 100 VA.
• Apply minimum 6.0 lb-in torque for tightening field wires into the terminal blocks.
Page 8 of 8 Document Edition 1.1