GE MTE18 Owner's Manual And Installation Instructions page 13

REvERSING THE DOOR SWING
REHANG THE REFRIGERATOR DOOR
7
1. Lower the refrigerator door onto the bottom
hinge pin .
2. While holding the door securely, use the new
left-hand middle hinge from the accessory kit
insert hinge pin into socket in door . Attach the
center hinge with two screws with a 5/16" socket
and ratchet .
Installation Instructions
(CONT.)
13
REHANG THE FREEZER DOOR
8
1. Lower the freezer door onto the center hinge pin .
2. Place the left top hinge so the pin fits into the door
socket . (Left top hinge and cover can be found inside
of the product . Call your Moffat Service provider
at 800 . 5 61 . 3 344 if parts are missing . Support the
door on the handle side and make sure the door
is straight and the gap between the doors is even
across the front . While holding the door in place,
tighten the top hinge screws . Do not overtighten
these screws . Tighten them until they are just snug,
and then turn them another one-half turn .
3. Snap the left top hinge cover over the hinge .
1" = 2 . 5 cm; 1' = 0 . 3 m