GE MTE18 Owner's Manual And Installation Instructions page 11

REvERSING THE DOOR SWING
REMOvE REFRIGERATOR DOOR
2
1. Remove all food from the inner door liner .
2. Tape the door shut with masking tape .
3. Remove the center hinge by removing two hinge
screws with a 5/16" socket and ratchet . Save the
center hinge and screws .
4. Remove the tape and tilt the door away from the
cabinet . Lift the door straight up to free its bottom
socket from the pin in the bottom hinge bracket .
5. Transfer plastic bushing from right side of top of
refrigerator door to the left side .
6. Set the door on a non-scratching surface with the
inside up .
7. Install the 2 hole plugs from the opposite side of
the cabinet to the screw holes vacated by the
center hinge removal .
Installation Instructions
(CONT.)
11
TRANSFER BOTTOM HINGE TO THE
3
LEFT
1. Using a 5/16 Socket
and ratchet, remove
the 2 screws from the
bottom hinge .
2. Move the bottom
hinge pin from the
right to the left side
with a thin-blade
screwdriver until the
shoulder of the hinge
pin is touching the
hinge .
3. Move the bottom
hinge from the right
to the left side and
tighten the 2 screws .
4. Install the 2 hole
plugs from the
opposite side of the
cabinet to the screw
holes vacated by
the bottom hinge
removal .
TRANSFER DOOR STOP TO THE LEFT
4
1. On both the refrigerator and freezer doors,
remove the screws from the door stop on the
right with a Phillips screwdriver .
2. Install the door stop on the left of each door .
1" = 2 . 5 cm; 1' = 0 . 3 m