Advertisement
Figure 3
STEP 3 (see figure 3)
Remove desired knockouts for junction box or toggle bolt mounting. Also remove the
larger rectangular knockout for routing of AC leads unless using the conduit knockout found on
top of the housing. Mount unit to wall or ceiling using fasteners supplied with junction box or
mount to wall using toggle bolts (not provided). Pull AC and remote lamp connectors through
rectangular knockout and reconnect to matching wire harnesses as shown in step two. Reinstall
the battery and connect the battery quick disconnect. Re-secure the Velcro battery strap to secure
the battery in place. If MR-16 type lamps have been specified, they have been shipped in small
individual cartons inside the larger shipping carton. They are installed by press fitting into the
ceramic lamp base inside each lamp head. Energize AC supply branch circuit and refer to page 5
for operating instructions.
Philips Lighting North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873, USA
Phone: 855-486-2216
www.philips.com/luminaires
No rigid conduit – Flexible conduit only
Philips Lighting Canada Ltd.
281 Hillmount Road,
Markham ON, Canada L6C 2S3
Phone: 800-668-9008
www.philips.com/luminaires
9140053520 February 2016
Advertisement
