Advertisement
Figure 1
STEP 1 (see figure 1)
Expose junction box mounting pattern by loosening velcro strap over battery or batteries
and removing them from the housing (leave velcro strap in the housing). A quick disconnect is
provided between the electronics and batteries. Be certain that this quick disconnect is
disconnected before attempting to remove batteries. If it is planned to use toggle bolts to mount
unit to wall, additional knockouts intended for this purpose can be found under the lenses. These
keyhole slots will accommodate #6 toggle bolts. Refer to the sketch above for instructions on
removing the lenses.
STEP 2 (see figure 2)
Locate 4 pole connector attached to transformer inside unit. Remove 6" long extension
cable and wire to AC supply as shown. Unused black or blue lead must be insulated to prevent
shorting. If your unit has battery capacity in excess of the wattage required by its internal lamp
heads, it will be provided with a 2 pole remote lamp connector as well. Remote lamp heads used
must match voltage of unit (6 or 12 volt) and the combined wattage of the internal and remote
lamp heads must not exceed the rated wattage of the equipment – refer to nameplate label for
maximum wattage. If unit is not used to power any remote heads, be certain to insulate the unused
orange and yellow leads to prevent shorting or discard the 6" orange/yellow extension cable.
Philips Lighting North America Corporation
200 Franklin Square Drive
Somerset, NJ 08873, USA
Phone: 855-486-2216
www.philips.com/luminaires
Figure 2
Philips Lighting Canada Ltd.
281 Hillmount Road,
Markham ON, Canada L6C 2S3
Phone: 800-668-9008
www.philips.com/luminaires
9140053520 February 2016
Advertisement
