Data Transfer - SARAD RTM1688-2 User Manual

SARAD GmbH 9
25.5°C 56%rH 1002mbar
... more records
__________________________
AP 1300 printer information: The printer is supplied by an internal rechargeable NiMH
battery which can re-charged using the 9V/270 mA AC/DC mains power adapter. It takes
about 15 hours to complete the charging process (full charged). During charging the LED
lights orange and blinks short green. A discharged battery is indicated by a short red blinking
LED. The LED blinks also red in case other problems.
To insert a new paper spool, the paper compartment can be opened by sliding the Lid
Release Button forward until the lid springs open. Unwind a small amount of paper from the
roll and insert the paper roll into the printer. Close the lid down, and the paper is loaded. For
more detailed information please look at the printer's operation manual.

Data transfer

The acquired measurement data can be downloaded to a PC using the serial interface.
Connect the PC interface cable (9-pin SUB-D female to 3-pin round male) to both, instrument
and PC COM port. If the PC is not equipped with a standard COM port a USB to serial
converter can be used. For further information read the software manual.
User Manual RTM1688-2 06-02-2019.docx