Checking Remote-Board Pairing; Changing Ride Mode - Boosted MINI Manual

EN

CHECKING REMOTE-BOARD PAIRING

The Connection and Mode Indicator will turn solid
blue when the board is paired. If the indicator is
not lit, check that the board is powered on. If the light
is still not lit, press the Multi-Button on the remote
5 times (5x), followed by pressing the Power Button on
tap 5x

CHANGING RIDE MODE

This board ships in Beginner Mode. Before following
the instructions below to switch modes, make sure
you have mastered the use of the remote and board.
Beginner: limited acceleration, top
speed of up to 11 mph, no hills.
Eco: moderate acceleration, top speed
of up to 16 mph, small hills.
Expert (Boosted Mini S):
speed of up to 18 mph, up to 20% grade hills.
Expert (Boosted Mini X):
speed of up to 20 mph, up to 20% grade hills.
Warning: The Throttle Wheel is much more sensitive
in Expert Mode.
To avoid getting thrown off the back of the board,
follow these tips:
• Place one foot over each truck.
• Keep a low center of gravity.
• Move the Throttle Wheel in small increments.
• Lean forward when accelerating.
• Lean backwards when braking.
10
Boosted Mini Manual
high acceleration, top
high acceleration, top
the board 5 times (5x) rapidly to pair your board.
Your board and remote have already been paired
prior to shipping, so you typically only need to
do this when pairing to a new board or remote.
tap 5x
To Cycle Through Modes
Come to a full stop. Tap the Multi-Button 3
times (3x) rapidly to change modes. Count the
LED flashes to identify which mode you are
in. Count the AUDIO beeps to identify which
mode you are in (1 beep, 2 beeps, 3 beeps).
tap 3x
1 beep / 1 flash
2 beeps / 2 flashes
3 beeps / 3 flashes