Monster Power PowerCenter HDP IR 2550 Owner's Manual page 21

5. Place the emitter heads over the IR eyes of the AV components you wish to control, but do not secure them
with the adhesive on the heads. Use masking tape to temporarily secure the heads while you test your setup. IR eyes
on your AV components (DVD player, TV, etc.) are typically located behind a dark window on the front
of the component's chassis. Consult your AV component's manual if you are unsure of the location of its IR eye.
6. Thoroughly test the temporary IR emitter setup with your remote to ensure it is working properly. Close the AV
cabinet doors so that your AV components are hidden. Aim your remote at
the external IR receiver and send remote commands (for example: power on,
change channel, volume up, etc.). Confirm that your commands are being sent
to your AV components, and that they are responding correctly. You may need
to fine tune the IR emitter head location. Simply remove the masking tape,
move the IR emitter head, re-secure it with masking tape, and re-test.
7. Once you have confirmed that your IR emitter setup works properly, you can
remove the temporary masking tape and affix the IR emitter heads to your
components by removing the adhesive backing on the emitter heads
and pressing them into place.
NOTE: Avoid having IR Emitters pointing towards the IR Receiver "Eye" built into the front of the PowerCenter, as this
may create an IR "feedback loop" that interferes with proper operation.
NOTE: For simplicity, the PowerCenter IR circuitry sends all remote IR commands to all the emitters simultaneously.
HOOK-UP AND OPERATION INSTRUCTIONS
15