Table of Contents
Advertisement
Installation Direct to Cold Water Line
Find the cold water supply
1
2
line and close the valve.
Connect the cold water line
5
4
adapter to the cold water
supply valve as shown.
As fittings vary you will need
to find the right size adaptors
at your local plumbing store.
CAUTION
Be sure the valves are all connected tightly to prevent leakage.
Be sure of where you want to install the ionizer as a hole needs to be drilled through the sink top to thread the tube.
Be sure you connect the unit to cold water as hot water can damage the unit.
This is a good time to double check and make sure all your fittings are tight and the tubing is secure in the fittings.
Check daily for any leaks during the first week after installation and check for leaks occasionally thereafter.
12
Disconnect the cold water
3
Separate the water line.
hose from the line. Make
sure it is the cold water hose
and not hot because hot
water will cause the unit to
malfunction.
Connect the plastic tubing
Connect hoses to the water
6
as shown.
inlet and acidic water outlet
then open the cold water
supply valve.
Operation Method
Alkaline Water discharge method
Acidic Water discharge method
Purified Water discharge method
Press the "ON/OFF" button and then select the
"ALKALINE" button and tap until the desired Alkaline
level displays on the screen.
The level indicator will display the level you selected.
To STOP collecting water, press the "ON/OFF" button.
Press the "ON/OFF" button and then select the
"ACIDIC" button and tap until the desired Acidic
level displays on the screen.
The level indicator will display the level you selected.
To STOP collecting water, press the "ON/OFF" button.
Press the "ON/OFF" button and then select the
"PURIFIED" button to start dispensing filtered,
Purifed water.
To STOP collecting water, press the "ON/OFF" button.
13
Advertisement
Table of Contents
