Sharp Carousel R-1210 Operation Manual & Installation Instructions page 10

U N P A C K I N G A N D I N S T A L L A T I O N I N S T R U C T I O N S
8 PREPARATION AND USE OF THE CARTON TO ASSIST
IN THE INSTALLATION OF THE MICROWAVE OVEN
Utilization of the carton may make installation easier.
1. Place carton upside down. See Figure 10.
2. Using cutting line around the carton, cut into two pieces (A) and (B).
See Figure 11.
3. Position oven to assist in mounting to the wall. See Figure 12.
Figure 11
MOUNTING OVEN TO THE WALL
Two people are recommended to attach the Microwave Oven to the
Mounting Plate.
1. Thread the Power Supply Cord through the hole made in the
bottom of the top cabinet. Install the oven by snapping it onto the
Mounting Plate. See Figure 13.
2. Use two Tapping Screws 5 to secure the levers that are on the
bottom of the oven. See Figure 14.
3. Use two Top Cabinet Screws 3 and two Flat Washers 6, supplied
in the INSTALLATION HARDWARE, to attach the unit to the top
cabinet. See Figure 15.
4. Make a bundle of the Power Supply Cord and attach it to the inside
of the cabinet using the Power Cord Hanger 4. See Figure 15.
Figure 14
(A)
(B)
Top Side
Figure 12
Figure 13
Figure 15
NOTE:
Screw length has been designed to accommodate
3/8" and above cabinet depth. If less, screw must
be cut to required length.
10
Figure 10
Cutting Line
4
3
6