Prepare The Hood - Sharp INSIGHTRANGEHOOD KB-0333K Installation Instructions And Operation Manual

PREPARE THE HOOD

Remove 7" Round
1
Duct Plate from top
of hood. Set duct
plate aside - with
mounting screws.
R e m o v e t a p e
2
holding Filters in
place. Pull down
on filter tabs or
finger holes and
lift filters out. Set
filters aside.
Remove Teflon -
®
3
Coat ed Bottom
Cover from hood.
S e t c o v e r a n d
mounting screws
aside.
Teflon is a registered
®
trademark of DuPont.
TEFLON
Remove Damper/
4
Duct Connector
f rom i nside t he
hood. Set connector
aside - with mounting
screws and parts
bag.
Remove either top
5
o r b a ck w i r i ng
knockout and install
approved Electrical
Cable Clamp.
® -COATED BOTTOM COVER
(Held in place with 2 screws)
DAMPER/ DUCT CONNECTOR
ELECTRICAL CABLE CLAMP
NON-DUCTED INSTALLATION - Skip to page 8.
The following Steps (6 thru 14) are for DUCTED
INSTALLATION ONLY.
R e m ove L i g h t
6
Panel - held in
place with (5) #8
screws. Disconnect
l ig h t a s s e m bly
w i r e h a r n e s s
(white connector).
Remove Air Chute
7
- held in place with
one (1) screw.
Note: Be careful
not to disconnect
any wires.
Remove Baffle from air chute.
8
6