Battery Replacement; Specifications - Honeywell SiX Series Installation Instructions

System Status and Sounder Indications
The SiXFOB can be used to control the Lyric Controller system (e.g., arm, disarm the system); and receive system
status information (armed status, not ready to arm, in alarm, in RF transmission mode, and more). Press and release
any button and observe the key fob. Refer to the table below for system status information.
G
/
G G 20 sec
3 sec
G
2-3 sec
G
G 2-3 sec
G 1 x
G 2 sec
LEDs
G = Green
On
=
R = Red

Battery Replacement

When the battery is low, the LEDs do not flash during
transmission. To replace the battery:
1. Remove the screw from the back housing and use a
screwdriver to gently separate the front and back
housings.
2. Use a screwdriver to carefully remove the battery.
3. Wait 10 seconds or press a key fob button for 2
seconds to ensure full power discharge.
4. Insert a new Lithium, 3V, 210mAh battery as shown.
Recommended replacement battery:
Maxell CR2032 or Duracell DL2032
5. Replace the front housing and secure the housings
with the cover screw.
BATTERY CAUTION: Risk of fire, explosion and burns. Do not recharge,
disassemble, heat above 212 F (100 C) or incinerate. Dispose of used
batteries properly. Keep away from children.

Specifications

:
Battery: Lithium, 3V, 210mAh; Maxell CR2032, Duracell DL2032
RF Frequency: 2.4GHz
Operating Temperature: 0° to 50° C / 32° to 122° F
(Agency compliance 0° to 49° C / 32° to 120° F)
Relative Humidity: 95% max. (Agency compliance – 93% max.),
non-condensing
Dimensions: 11 mm H x 65.5 mm L x 36 mm W / 0.43" H x 2.58" L x 1.42" W
System Status Indications
R
2 x
R 2-3 sec
4 x
R 2-3 sec
1 x
1 sec
= Slow Flash
System Status
Device Enrollment
System is Armed
Alarm in progress or System in Audible Panic Mode
Disarmed, Ready to Arm
Disarmed, Not Ready to Arm
RF Transmission
Not Hearing from the Controller
Deleting the Keyfob from the system
/
= Rapid Flash
R
3
0
Wait about
10
45
10 seconds
30
or
press for 2 seconds
2
Sounder
= Chirp
=
LEDs Alternate
1
Maxell CR2032
Duracell DL2032
4
Approval Listings:
FCC / IC
cETLus Listed
Conforms to UL 1023 & UL 985
Certified to ULC ORD- C1023
& ULC-S545
Other Standards:
SIA CP-01 RoHS C-Tick
Product must be tested at least once each
year.
= Beep
2
5