Binding Cables; Preparing The Remote Control Unit; Installing The Batteries; Remote Control Operation Range - Sharp PN-525U Operation Manual

Cable clamp
positions
Cable clamp
attachment
1
Band
Power cord
Fastened
clamp
part

Preparing the Remote Control Unit

Installing the batteries

1. Press the cover gently and slide it in the direction of the
arrow.
2. See the instructions in the compartment and put in the
supplied batteries (2 "AA" size batteries) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.
TIPS
• The supplied batteries (2 "AA" size batteries) may become
exhausted faster depending on the storage condition. It is
recommended that you replace them with new batteries
(commercially available) earlier than specified.
• If you will not use the remote control for a long time,
remove the batteries.
• Use manganese or alkaline batteries only.

Binding Cables

Insert the cable
clamp into a hole.
(any hole available)
Cable clamp
2 3
Hole for
the power
cord clamp
Attaching the cable clamp
The cables connected to the terminals on the back of the
monitor can be neatly bundled using the supplied cable
clamps as shown in the illustration.
Caution
• Verify the position for attaching a cable clamp in advance.
A cable clamp cannot be removed once it is attached.
Fastening the power cord
The power cord can be fastened using the supplied power
cord clamp. This will prevent the power cord from being
disconnected accidentally.
1. Attach the supplied power cord clamp to the power
cord, making sure the power cord clamp is circular hole-
sidedown.
2. Insert the tip of the band into the hole for the power cord
clamp.
3. While holding the tail of the band, slide the fastened part
toward the AC input terminal.

Remote control operation range

The operation range of the remote control unit is approx. 16.4
feet (5 m) at an angle of approx 10° from the center to the
top/bottom/right/left of the remote control sensor.
16.4 feet (5 m)
16.4 feet (5 m)
10°
10°
TIPS
• Do not expose the remote control unit to shock by dropping
or stepping on it. This could lead to a malfunction.
• Do not expose the remote control unit to liquids, and do not
place it in an area with high humidity.
• The remote control unit may not work properly if the remote
control sensor is under direct sunlight or strong lighting.
• Objects between the remote control unit and the remote
control sensor may prevent proper operation.
• Replace the batteries when they run low as this may
shorten the remote control's operation range.
• If a fluorescent light is illuminated near the remote control
unit, it may interfere with proper operation.
• Do not use it with the remote control of other equipment
such as air conditioner, stereo components, etc.
Remote control sensor
13
E