Sharp PN-455RU Operation Manual page 45

If execution of the command is taking some time
W A I T
No ID number is attached to WAIT response.
• Commands which return WAIT:
- When repeater control is used
- When an IDSL or IDLK command is used
- When one of the following commands is used: RSET, INPS, ASNC, WIDE, EMAG, EPOS, PXSL,
POWR, AGIN, MWIN, MWIP, MWPP.
When control via RS-232C is locked (to prevent use) using the operation lock function (see
page 34)
L O C K
If the current parameter is read out using "?" for the parameter (for numerical values etc.)
• Response when no ID number has been set
Example:
VOLM????
0
• Response when an ID number has been set (In the example below: ID number = 1)
Example:
VOLM????
0 00
<Communication interval>
• After OK or ERR is returned, you must send the following commands. To set a timeout for the
command response, specify 0 seconds or longer.
• Provide an interval of 100 ms or more between the command response and the transmission of the
next command.
VOLM000
OK
INPS000
WAIT
OK
Return code
(0D , 0A )
H H
Return code
(0D , 0A
H
E D
Interval of 00 ms or more
When the following commands are used, "WAIT"
is returned. In this case, a value will be returned
if you wait a while. Do not send any command
during this period.
)
H

E