Advertisement
Parts Included:
1. Foam Tape - 4" Long (x6)
2. Foam Tape - 24" Long (x2)
3. Surface Mount
4. Screw A (x5) - Pan Head, course pointed screw for wood
5. Screw B (x5) - Truss Head, self-drilling screw for metal studs
6. Plastic Grommet / Drain Hose Bushing
Tools Required:
• Drill / Screwdriver
• Long Bit Extender (optional)
Step 1.
Install Foam Tape to Surface Mount Kit
Identify the front side of the
surface mount kit by locating the
semi-circular cutouts along the
inside edge.
Install 4" foam tape to the front
as shown. Do not cover holes for
fastening.
Install 24" foam tape to the back
as shown. Do not cover holes for
fastening.
In-Wall Dehumidifier
Surface Mount Kit
Part No. 4037766
FRONT
4201 Lien Rd Madison, WI 53704 • TOLL-FREE 1-800-533-7533 • www.thermastor.com • sales@thermastor.com
1
2
4"
(x5)
4
3
(x5)
5
6
BACK
TS-1050 7/18 Rev D
24"
CONTINUED
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Therma-Stor 4037766
Summary of Contents for Therma-Stor 4037766
-
Page 1: Tools Required
In-Wall Dehumidifier Surface Mount Kit Part No. 4037766 Parts Included: (x5) 1. Foam Tape - 4" Long (x6) 2. Foam Tape - 24" Long (x2) 3. Surface Mount 4. Screw A (x5) - Pan Head, course pointed screw for wood (x5) 5. - Page 2 Step 2. Attach Surface Mount to Wall Locate studs inside the wall 16" apart. Place the surface mount on the wall and ensure it is level. Locate the four holes on the surface mount and fasten to the wall with the appropriate screws based SCREW A or B on the stud type.
- Page 3 Step 4. Install In-Wall Dehumidifier to Surface Mount Lift and support the dehumidifier by the plastic drain pan below the evaporator coil and place inside of the surface mount. Two people are recommended for this step. Route the drain hose and electrical wiring through the corresponding knock out holes of the surface mount and dehumidifier to connect.
- Page 4 Step 5. Install Diffuser Cover Place the hooks of the front diffuser cover into the slots at the base of the dehumidifier before fastening. SECURE BOTH HOOKING LOCATIONS Locate the four holes on the diffuser cover and fasten to the dehumidifier using either Screw C (Tamper Resistant) or Screw D (Phillips Head) included with the unit.
Need help?
Do you have a question about the 4037766 and is the answer not in the manual?
Questions and answers