Tv Screen Display Mode; Sleep Timer - Sharp LC-20SH7U Operation Manual

W
ATCHING TV

TV Screen Display Mode

DTV
2 types of display modes can be selected in the digital mode when the
broadcasting station is sending 16:9 video signal.
Press [VIEW MODE] repeatedly to switch the TV aspect
ratio.
VIEW MODE
LETTERBOX
[LETTERBOX]
Display the digital-supported program in full-screen.
Black borders will spread in the upper and lower
screen.
[ZOOM]
Enlarge and display the center area of the digital-
supported program.
The right and left side of image will be cut off.
Note:
• You may not switch the display mode depending on the
program.
• In "INPUT 2" of the external input mode, you can also select
the display mode either "4:3 (normal)" or "WIDE" when the
connected external device outputs 480p video signal and
the following is displayed on the TV screen.
Select "WIDE" accordingly if your DVD video is recorded as
anamorphic widescreen.
4:3
18
EN
The sleep timer can be set to automatically turn off the unit after an
incremental period of time.
1
2
ZOOM
INPUT 2
480P
WIDE

Sleep Timer

Press [SLEEP] to set the sleep timer.
SLEEP
• Sleep timer display appears on the TV screen.
Press [SLEEP] repeatedly to change the amount of
time until shut off.
SLEEP
• You can set your unit to turn off after a set period of
time (from 30 to 150 minutes).
• Each press of [SLEEP] will increase the time by 30
minutes.
• After set up, the sleep timer display can be called up
for checking by pressing [SLEEP].
To Cancel the Sleep Timer
Press [SLEEP] repeatedly until "SLEEP OFF" is displayed
on the TV screen.
Note:
• The sleep timer setting display will automatically disappear
in 10 seconds.
• When you disconnect the unit from the AC outlet or when a
power failure occurs, the sleep timer setting will be canceled.
SLEEP OFF
SLEEP 120MIN.