TruAudio T100 User Manual

TruAudio T100 User Manual

2-channel amplifier

Advertisement

Quick Links

2-CHANNEL AMPLIFIER
BY
User Manual - T100

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T100 and is the answer not in the manual?

Questions and answers

Summary of Contents for TruAudio T100

  • Page 1 2-CHANNEL AMPLIFIER User Manual - T100...
  • Page 2: Box Contents

    The T100 was designed to be a cost-effective way to add audio to any home. Using the latest digital technology, the T100 is able to run much cooler than a standard class AB amplifier, meaning it can be placed in almost any dry location.
  • Page 3: Dip Switches

    HP 80 Hz - The internal crossover limits all frequencies below 80Hz, going to the speakers. 5. IN 1, IN 2 - If the T100 loses power or if the hard power switch is turned off, the amplifier will default to the input set by the dip switch when power is restored.
  • Page 4 NOTE: If using a Toslink from the TV to the amp T100 and you don’t hear audio, or the audio is garbled then set the audio coming from the TV or cable box to PCM stereo.
  • Page 5 Bridge Mode Bridge mode combines both the left and right channels to a single channel mono signal output. Bridge mode is stable down to a minimum load of 8Ω. Power output bridged: 275W @ 8Ω 8Ω LOAD 8Ω IR Connection, Control and Learning Learning This amplifier can learn the following commands (off, on, mute, volume down &...
  • Page 6 6. After last button is programmed the blue light will stay on or turn red if no audio source is plugged into the T100. 7. Set dip switch #2 up to IR SET 8. You are now programmed. *When learning IR commands, the T100 will always learn in the following order.* Programming sequence: • Power off • Power on •...
  • Page 7 All subwoofers and amplifiers have a limited 5 year warranty. This warranty includes 5 year parts and repair labor on all components. The warranty extends only to the original purchaser of the product and not to any subsequent owner. TRUAUDIO’s obligation under these warranties is limited to repairing or replacing any component found defective in material or workmanship under normal conditions of use with an equal and/or current product.

Table of Contents