Advertisement
EN
IMPORTANT
Please read these instructions carefully before you start to assemble this product.
Keep these instructions in a safe place for future reference.
a Customer Service
For assistance with assembly, replacement parts or any other additional information
please log onto our website or call our customer service line (number is on the title page).
www.palramapplications.com
a Safety advice
•
It is of utmost importance to assemble all of the parts according to the directions.
Do not skip any step.
•
We strongly recommend using work gloves during assembly.
•
Always wear shoes and safety goggles when working with extruded aluminium.
•
If using a step ladder or power tools ensure that you follow the manufacturer›s safety advice.
•
Do not touch overhead power cables with the aluminium profiles.
•
Do not attempt to assemble the product in windy or wet conditions.
•
Dispose of all plastic bags safely keep them out of reach of small children.
•
Keep children away from the assembly area.
•
Do not lean against or push the product during construction.
•
Do not position your product in an area exposed to excessive wind.
•
Do not attempt to assemble this product if you are tired, have taken drugs or alcohol or if you
are prone to dizzy spell.
•
Hot items such as recently used grills, blowtorches etc. must not be stored in the product.
•
This product is designed to use as growhouse only.
a Care & Maintenance
When your product needs to be cleaned, use a mild detergent solution and rinse with cold clean
water. DO NOT use acetone, abrasive cleaners or other special detergents to clean the clear panels.
a Tools & Equipment
•
Tape measure
•
Work gloves
•
Phillips head screwdr iver
•
Drill bit
•
Large hammer
•
T001 - Special tool for Screws 411 and nuts 412
a Before Assembly
This is a multi-part assembly best achieved by two people.
Allow at least half a day for assembly process.
Selecting a site - the product must be assembled, positioned and fixed
on a flat level surface.
Choose a sunny position away from overhanging trees.
Take out all components parts of the packages. Sort the parts and
check against the contents parts list.
During assembly parts should be laid out close at hand. Keep all small
parts (screws etc.) in a bowl so they do not get lost.
a Notice
Step 7 – To level the shelves make sure the distances between floor and shelf are
equal on 4 corners. Shelves height can be adjusted to your needs.
Make sure screws are strongly tightened.
Steps 21-22 – The magnetic door catcher (1079) should be connected so it can
hold the nut on the door.
Step 25 – Make small holes on the back panel before it is screwed to shelves.
Step 26 – If door is not closing properly, bolt and nuts can be used to level the
product
a After assembly
This product's ground fixing is based on storage weight. When shelves are empty
or light weight loaded it should be kept from winds. There for we are strongly
recommending fixing the product directly to a solid foundation.
Advertisement
