Remote Transmitter Operation - JEFF ROWLAND CONTINUUM S2 Operational Manual

REMOTE TRANSMITTER OPERATION

The is equipped with a wireless, infrared (IR) remote transmitter, allowing
CONTINUUM S2
convenient wireless control of the most commonly used functions from the listening position.
An explanation of these functions and battery installation follows.
NOTE:
Housing the integrated ampli er in extremely high ambient light conditions may cause
erratic remote control operation. The IR sensor, located within the volume level display, must
not be exposed to direct sunlight or spotlights.
(1) DISPLAY DIM:
Press once to dim display one level of
brightness. Press again to resume default level of
brightness.
INPUT SELECT 1-4:
(2)
buttons will select the desired input. The input number
corresponding to the numbering of the inputs on the
rear panel.
INPUT SELECT 5 BYPASS:
(3)
the BYPASS input.
MUTE:
(4) This button will immediately mute the outputs
of the integrated ampli er. The volume display will
continue to show the present location of the volume
control. Pressing this button a second time will
reactivate the outputs of the integrated ampli er.
VOL UP:
(5) The VOL UP
level of the integrated ampli er in 0.5 dB increments.
Holding this button down will cause the volume level
to continuously increase until the button is released or until 99.5 is displayed on the
volume display.
(6) VOL DOWN:
The VOL DOWN
ampli er in 0.5 dB increments. Holding this button down will cause the volume level to
continuously decrease until the button is released or until 00.0 is displayed on the volume
display.
PHASE:
(7) Press once to invert absolute phase.
again to return integrated ampli er to non-inverted absolute phase.
panel will turn off.
The IN 1 , IN 2 , IN 3 , and
The IN 5 button will select
button will increase the output
button will decrease the output level of the integrated
REVA1.9 - CONTINUUM S2 INTEGRATED AMPLIFIER
IN 4
PHASE LED on front panel will light. Press
PHASE LED on front

PAGE 17