Advertisement
ZIO™ LCD WALL MODULES
Fig. 8. Sample Contractor parameter display showing
user-created discharge air parameter value.
Fig. 9. Sample Contractor parameter display showing
sensor setpoint value (CO
NOTE: Any configured parameter may be displayed.
ComfortPoint™ is a trademark of Honeywell International Inc.
L
M
® is a trademark of the LonMark Association.
ON
ARK
Spyder™ is a trademark of Honeywell International Inc.
Sylk™ is a trademark of Honeywell International Inc.
Zio™ is a trademark of Honeywell International Inc.
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
customer.honeywell.com
® U.S. Registered Trademark
© 2008 Honeywell International Inc.
63-1322—01
M.S. 10-08
M27358
M27359
sensor from controller).
2
Honeywell Limited-Honeywell Limitée
35 Dynamic Drive
Toronto, Ontario M1V 4Z9
TYPICAL SPECIFICATION
1. The wall module shall have an LCD display.
2. The wall module shall have a customizable home
screen:
a. Shall have the option to show up to 3 parameter
values on a single display.
b. Shall have the option to show occupied status.
c. Shall have the option to show system status.
d. Shall have the option to show fan status.
e. Shall have the option to show up to three of the
following parameters:
(a) room temperature, setpoint, outside tempera-
ture, room humidity, outside humidity, time of
day.
f.
Shall have the option to show on the home screen
any single parameter in the controller, with a user
defined 8 letter name.
3. The wall module shall offer access to all parameters
necessary to balance a VAV system.
4. The wall module shall offer the ability to restrict access
to parameter information with keypad enabled lock out.
5. The wall module shall retain user configuration including
setpoints after power outage.
6. The wall module shall use a two wire polarity insensitive
connection for all communication and power needs.
7. The wall module shall offer the ability to access and
adjust user chosen controller parameters.
8. The wall module shall offer the ability for the tenant to
adjust override time period within the limits set by the
contractor.
9. The wall module shall offer a communication jack for
remote access to the network.
10. The wall module shall offer a ± 5% on board humidity
sensor (TR70-H only).
11. The wall module shall be configured through the Tridium
Niagara workbench tool.
12. The wall module shall communicate with other devices
using the Sylk bus protocol.
Advertisement
