Sharp UX-K01 Operation Manual

2.4 ghz cordless handset
Hide thumbs Also See for UX-K01:

Advertisement

Quick Links

MODEL
UX-K01
10
Charge the battery for about
hours before initial use.
1. Introduction
2. Connecting the Cordless Handset Charger
3. Installing and Charging the Battery
4. Registering the Cordless Handset
5. Enterring a Name for the Cordless Handset
6. Maintenance

Advertisement

Table of Contents
loading

Summary of Contents for Sharp UX-K01

  • Page 1 MODEL UX-K01 Charge the battery for about hours before initial use. 1. Introduction 2. Connecting the Cordless Handset Charger 3. Installing and Charging the Battery 4. Registering the Cordless Handset 5. Enterring a Name for the Cordless Handset 6. Maintenance...
  • Page 2: Specifications

    As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units.
  • Page 3: Important Safety Information

    Important safety information Do not disassemble this product or attempt any procedures not described in this manual. Refer all servicing to qualified service personnel. Do not this product near water, or when you are wet. For example, do not use the product near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool.
  • Page 4: Installing And Charging The Battery

    Connecting the Cordless Handset Charger Connect the AC adapter to the cordless handset charger. Plug the AC adapter into a standard 120 V AC outlet. Important: Never cover the charger and AC adapter with a blanket, cloth, or other material. Excessive heating may result and cause fire.
  • Page 5 Place the cordless handset in the charger with the dial pad facing forward. • Important! The dial pad must face forward, or the battery will not charge. • The battery charges automatically while the cordless handset is in the charger. While charging, the display shows CHARGING.
  • Page 6 Registering the Cordless Handset After the initial charging, the cordless handset display shows: PLEASE REGISTER On the cordless handset, hold down INTER until the display at right appears. Press on the cordless handset. • If FAX BUSY appears in the display, wait until the fax machine is no longer in use and then start from Step 1 again.
  • Page 7 The fax machine is identified by the number “0”, and the cordless handset that was included with the fax is identified by the number “1”. Entering a Name for the Cordless Handset Enter a name for the cordless handset in the fax machine. ♦...
  • Page 8: Own Number

    Enter the name by pressing number keys for each letter as shown in the chart below. Up to 10 characters can be entered. Example: BILL = 22 444 555 SPACE = ♦ To enter two letters in succession that require the same key, press after entering the first letter.
  • Page 9: Maintenance

    If LOW BATTERY continues to appear in the cordless handset display after the battery has been charged for 10 hours, replace it with the following battery: Replacement battery: Use only a Sharp UX-BA01 battery (3.6 V Ni-MH battery, capacity: 850 mAh) Caution: Danger of explosion if battery is incorrectly replaced.
  • Page 10 Deleting a cordless handset If you wish to stop using a cordless handset, follow these steps to delete it (cancel the registration in the fax machine). On the cordless handset, hold down INTER until the display at right appears. Press on the cordless handset.
  • Page 11 If trouble is experienced with this equipment, or for repair or warranty information, please contact Sharp's Customer Assistance Center. The number is 1-877-794-8675. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.
  • Page 12: End User Limited Warranty

    In no event shall Sharp be liable, or in any way responsible, for any damages or defects in the Product which were caused by repairs or attempted repairs performed by anyone other than an authorized servicer.
  • Page 13: Important Service Information

    How Exchange is Obtained A replacement unit in exchange for your fax is provided by Sharp to any U.S. location. You will be required to provide consent for acceptance of an exchange unit and provide credit card authorization. At that time, Sharp will ship to you, at no cost, an exchange for your defective product. The exchange unit we ship to you will be new or remanufactured.
  • Page 14: For Your Records

    SHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey 07430-2135 http://www.sharpusa.com SHARP CORPORATION FOR YOUR RECORDS Please record the model number and serial number below, for easy reference, in case of loss or theft. These numbers are located on the rear side of the unit. Space is also provided for other relevant information.

Table of Contents