Lanberg RO Series Quick Installation Manual page 26

Quick Installation Guide
Broadband routers
If you need to configure one of
following Internet connection
(WAN) modes: DHCP, Static IP
address, PPPoE, PPTP, L2TP (3.5.1 -
3.5.5), press the „Setup Wizard"
button.
3.5.1) WAN interface setup of the router in DHCP mode
3.5.2) WAN interface setup of the router in the static IP address mode
„Secondary DNS Address" with an additional IP address in case of communication failure with the
primary DNS server,
Step 3) Press „Next button",
Step 4) Further part of the configuration (Wi-Fi) is described in 3.5.11 section.
E-mail: support@lanberg.eu
www.lanberg.eu
Step 1) On newly opened window, select the
Step 2) If your Internet provider (ISP) filters the
Step 3) Press „Next" button,
Step 4) Further part of the configuration (Wi-Fi)
Step 1) On newly opened window, select the
Step 2) Input the value of the „IP Address" field
Lanberg © 2015-2018
entry „DHCP client" from the „WAN
Access Type" drop-down list,
access to the network using the expected
MAC address, enter this value in the
„MAC address" field,
is described in 3.5.11 section.
entry „Static IP" from the „WAN Access
Type" drop-down list,
by entering the IP address on which the
router will be available on the WAN
interface. Complete „Subnet Mask" and
„Default Gateway" value fields as well,
so they are compatible with the values
defined on the WAN interface. Next fill in
„Primary DNS Address" field, by entering
the IP address of the server translating
domain names into IP addresses. You can
additionally complete the field
PL | EN
26 | 32