Advertisement
Available languages
Available languages
Quick Installation Guide
Broadband routers
LAN port(s)
Internet port (WAN)
WPS button
Wi-Fi button
3) Connecting and configuring your router and devices connected to it
Reset button
3.1)
Resetting Lanberg's router(s) its default factory settings
Depending on the router model, the reset button is located:
•
RO-030FE, RO-120GE model: underneath the device,
•
RO-175GE model: at the back of the device,
To reset the device, press and hold the Reset button for at least 6 seconds. Then disconnect or turn off the
power for at least 15 seconds and then connect the router's power back or turn it back on.
E-mail: support@lanberg.eu
www.lanberg.eu
Allows you to directly connect up to 4 devices within
• RO-030FE model: 4 x 100Mbps ports
• RO-120GE, RO-175GE model: 4 x 1000Mbps ports
Allows you to connect your router to internet
• RO-030FE model: 1 x 100Mbps port
• RO-120GE, RO-175GE model: 1 x 1000Mbps port
Press and hold the button for at least 3 full seconds
to activate the WPS function. The WPS LED will start
to blink. Turn the WPS feature on the end device
(e.g. wireless network card, wireless range extender
or wireless IoT device), by pressing a similar WPS
button (if available). Make sure to do so, within 2
min. of turning on the WPS feature of your router.
Press and hold the button for at least 3 full seconds
Press and hold the button for at least 6 full seconds
to restore the device to the default settings.
Lanberg © 2015-2018
local network to the router
provider's (ISP) network
to turn the Wi-Fi on / off.
PL
| EN
20
|
32
Advertisement
