Automatic Transmission - GMC Canyon 2019 Quick Reference Manual

CRUISE CONTROL
SETTING CRUISE CONTROL
1. Press the On/Off button. The
on the instrument cluster.
2. When traveling at the desired speed, press the SET– button to set the speed. The
symbol will illuminate in green on the instrument cluster.
ADJUSTING CRUISE CONTROL
RES+ Resume/Accelerate
Press to resume a set speed.
When the system is active, press once to
increase speed 1 mph; press and hold to
continue increasing speed.
SET– Set/Coast
When the system is active, press once to
decrease speed 1 mph; press and hold to
continue decreasing speed.
Cancel
Press to cancel the Cruise Control without erasing the set speed from memory.
Pressing the brake pedal also will cancel the Cruise Control.
The set speed is erased when Cruise Control or the vehicle ignition is turned off.

AUTOMATIC TRANSMISSION

DRIVER SHIFT CONTROL
Driver Shift Control allows the driver to select
the range of gears desired for the current
driving conditions.
1. Move the shift lever to the L (Manual)
position.
2. Press the + (plus) or – (minus) button on
the shift lever to select a lower or higher gear. An L and the current gear will be
displayed on the Driver Information Center.
The transmission will be limited to the gear selected and lower gears. If vehicle speed
is too high or too low for the requested gear, the shift will not occur.
TOW/HAUL MODE
The Tow/Haul Mode adjusts the transmission shifts to reduce shift cycling, such as
when towing or hauling heavy loads or driving on steep grades.
Press the
turn the system on or off.
Optional equipment
F
F
Tow/Haul Mode button on the center of the instrument panel to
Cruise Control symbol will illuminate in white
See Driving and Operating in your Owner's Manual.
See Driving and Operating in your Owner's Manual.
13