Table of Contents
Related Manuals for Milwaukee M28 48-59-2819
Summary of Contents for Milwaukee M28 48-59-2819
- Page 1 OPERATOR'S MANUAL Cat. No. 48-59-2819 New battery packs must be charged before first use. Cat. No. 48-11-2830 ® M28™ & V28 LITHIUM-ION BATTERY CHARGER M28™ LITHIUM-ION BATTERY PACKS WARNING To reduce the risk of injury, user must read and understand operator's manual.
-
Page 2: Important Safety Instructions
CHARGE MILWAUKEE 28 VOLT LITHIUM- 13. DO NOT BURN OR INCINERATE BATTERY PACKS. Battery packs may explode, causing per- ION PACKS ONLY IN THIS MILWAUKEE 28 VOLT LITHIUM-ION CHARGER. Other types of sonal injury or damage. Toxic fumes and materials chargers may cause personal injury or damage. -
Page 3: Functional Description
Charge Time ..........1-Hour Operating Temperature Double Insulated Battery and Charger ....32°F to 150°F (0°C to 65°C) Battery and Tool ........0°F to 167°F Hertz (-18°C to 75°C) *Charges MILWAUKEE 48-11-2830 M28 ™ 48-11-2830 V28 ® Li-Ion battery packs. Amps MILWAUKEE Properly Recycle Batteries... -
Page 4: Charger Operation
MILWAUKEE Charger a risk of injury. Remove the battery pack from the tool for charging when convenient for you and your job. MILWAUKEE Store battery packs at room temperature away from moisture. Do not store in damp locations where cor- batteries do not develop a "memory"... - Page 5 Never disassemble the battery pack or charger. Contact a MILWAUKEE service facility for ALL repairs. To reduce the risk of injury and damage, never immerse your battery pack or charger in liquid or allow a liquid to flow inside them.
Need help?
Do you have a question about the M28 48-59-2819 and is the answer not in the manual?
Questions and answers
I have a 28 volty90 degree drill. It does not seem to have much power any longer. When I charge the battery the charger indicates green for full power. The battery indicate four red bars but the drill does not work well. It is like the battery is weak. What gives?
Power issues with the Milwaukee M28 48-59-2819 28-volt drill, despite the battery showing a full charge, could be caused by:
1. High Current Draw: In situations of high torque, binding, or stalling, the tool may shut off to protect the battery. The tool may buzz briefly before turning off, and the Fuel Gauge lights will flash 8 times.
2. Overheating: If the internal temperature of the battery becomes too high, the battery will shut off. The Fuel Gauge lights will flash alternately when the button is pressed.
3. Cold Battery: If the battery is too cold, it may not function properly until it reaches the correct temperature.
4. Faulty Battery: A flashing red/green light indicates a damaged or faulty battery pack.
In such cases, reduce pressure on the tool, allow the battery to cool, or check for battery faults.
This answer is automatically generated