National Flooring Equipment PANTHER 8274 Instruction Manual page 15

8274/9274 PROCEDURE
BELT (CONTINUED)
BELT TENSION
NOTE: IF THE TENSION IN NOT PROPERLY TIGHTENED, THE TOOLING WILL SLIP AND NOT PERFORM
AS DESIGNED
8274
•Loosen (do not remove) two of the three tension bracket bolts (Figure A)
•Pivot the loosened bracket so it is evenly spaced with the center pulley (Figure B & C)
•Apply pressure with a pry bar between the gear plate and tension bracket (Figure D), tighten both bolts
•Recheck the spacing between the brackets and the center pulley (Figure B & C)
•Belt should be tightened to have less than ¼" of movement (Figure E)
9274
•Loosen (do not remove) both bolts on one of the tension brackets (Figure F)
•Pivot the loosened bracket so it is evenly spaced with the center pulley (Figure G & H)
•Apply pressure with a pry bar between the gear plate and tension bracket (Figure I), tighten both bolts on
the bracket
•Recheck the spacing between the brackets and the center pulley (Figure G & H)
•Belt should be tightened to have less than ¼" of movement (Figure J)
Figure A
Figure F
Brackets
Brackets
Center Pulley
Figure B Figure C
Brackets
Brackets
Center Pulley
Figure H
Figure G
Page 15
Pry Bar
Figure D
Figure E
Figure J
Figure I