Setting Extra Suction Time; Vacuum Packing Food; Safety Features; Safety Cut-Out - Buffalo CC770 Instruction Manual

SETTING EXTRA SUCTION TIME

1. Again, make sure machine is switched On [l] and the lid is raised
2.
Simultaneously press the
Note: if not pressed at the same time you may accidentally select a different mode –
check that you are still in the mode you want to customize
3. To adjust the Extra Suction time, press and hold the
Note: expressed in seconds as 1 to 9 then A to F on CC770 (A for 10, B for 11, C for 12,
D for 13, E for 14 and F for 15) and as 1 to 15 on CC771
4. Press and hold the 'STOP/OK'
5. You are now back to the operating mode selected with its default Sealing Time being
displayed
Note: the default Suction Time is 95 seconds and cannot be reduced
Note: constant use of extended Suction Time will shorten the life of the appliance

VACUUM PACKING FOOD

1. Place the food in the bag
Note: never fill bag over 70% capacity
2. Remove any excess liquid or food residue
3. Lift the into locked position
4. Place the open end of the bag over
the Channel
5. Lower the lid and press down to start
the suction process
6. Maintain pressure on the lid for best results
7. CC771 only – pressure is displayed before
sealing countdown begins
8. Once the suction time is reached, the sealing process begins
Note: the process can be stopped at any time by pressing the STOP/
Note: the sealing can be started as early as you want by pressing 'WELDING M1-M2-M3'
9. CC770 – 'E' for End is displayed once process is completed, remove bag
CC771 – 'END' is displayed once process is completed, remove bag
WARNING: Never lift the lid from underneath as the sealing bar remains hot.
Make sure to ALWAYS lift it from the side to avoid injuries
Note: the lid may be hard to open for a few seconds after operation due to vacuum pressure
and you may need to allow a few seconds for the pressure to dissipate before lifting the lid

SAFETY FEATURES

Safety Cut-out: this appliance is fitted with an automatic safety system to help prevent
any damage from misuse – if during the suction process the pressure gets too great (no air
left in the bag) the appliance automatically switches to the sealing process.
Anti-stress Safety: this appliance is also fitted with an automatic anti-stress safety system
to help prevent any damage from overuse – if machine alternatively displays 'E' followed by
'A', leave the machine on for 10 minutes as it will then automatically turn off the machine
and reset the counter. E.g. the Anti-stress Safety kicks in after M1 or M2 (extreme modes)
have been used 5 times consecutively

AUTO-STANDBY

This appliance will automatically go into Standby Mode if unused for 4½ minutes. In order
to switch the unit back on, simply press any button for 1 second and wait 10 seconds for the
machine to turn itself back on.
and 'Welding M1-M2-M3' buttons for 3 seconds
button to save the suction time and exit
or buttons
button
OK
UK
6