Bosch CTL636ES1 Instruction Manual page 58

en
F Important:
Before starting each service program
(Descale, Clean or Calc'nClean)
remove the brewing unit, clean as
instructed and replace it�
Be careful not to jam the milk tube
when closing the door�
After completion of each service
programme, wipe the appliance
immediately with a soft, damp cloth
to remove any residues from the
descaling and cleaning solution� It is
possible for corrosion to form under-
neath such deposits�
New sponge cloths may contain
salts� Salts can cause rust film on
stainless steel and must therefore be
washed out thoroughly before use�
Clean the beverage outlet, milk tubes
and connecting piece thoroughly�
F Specially developed, suitable
descaling and cleaning tablets are
available from retail outlets or from
customer services (see the section
"Accessories")�
Descaling
Takes about 21 minutes�
● Touch E�
● Touch [ Descale ] to select the
programme�
● The display indicates the progress
of the programme�
● Empty drip trays and replace�
● Remove the water filter (if there is one)
and press C
● Pour lukewarm water into the empty
water tank up to the "0�5 l" mark and
then dissolve one Bosch descaling tablet
TCZ8002 in it� For the TCZ6002 you
should always dissolve two tablets�
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
F If there is not enough descaling solu-
tion in the water tank, you will be asked
to do the following� Refill using uncar-
bonated water and press C again�
● Remove the milk tube from the milk
container and fix the connecting part to
the right side of the beverage outlet with
the magnet�
● Close the appliance door�
● Place a container with a capacity of
0�5 litre under the beverage outlet�
● Put the end of the milk tube into the
container�
● Press C� The descaling programme will
now run for about 19 minutes�
● Remove the container and press C�
● Rinse the water tank and (if removed)
replace the water filter.
● Fill the tank with fresh water up to the
"max" indicator�
● Replace the water tank and close the door.
● Place the container underneath the
beverage outlet again�
● Put the end of the milk tube into the
container�
● Press C� The descaling programme will
now run for about 2 minutes and rinse the
appliance�
● Remove the container, empty the drip
trays, replace and close the appliance door�
● Press C. The appliance has finished
descaling and is ready for use again�
● Touch E to exit the program�
Cleaning
Takes about 5 minutes�
● Touch E�
● Touch [ C lean ] to select the programme�
● The display indicates the progress
of the programme�
● Clean the beverage outlet and replace,
empty the drip trays and replace�
● Open the ground coffee drawer, drop in
a cleaning tablet and close the coffee
drawer again�
53
CTL636E.. | 07/2014