Table of Contents
Advertisement
Quick Links
LOGIC CONFERENCE TABLE
HBF
GENERAL NOTES
1. ALWAYS PROTECT THE WORKSURFACE DURING INSTALLATION.
2. ALWAYS LEVEL UNIT(S) AT FINAL LOCATION.
3. TWO PERSON ASSEMBLY REQUIRED
HARDWARE
A
B
WIRE MANAGER
1 1/8 GLIDE
1 INSTALL GLIDES
-THREAD IN ALL ADJUSTABLE GLIDES (A)
INTO BASE GLIDE HOLES
2 ATTACH WIRE MANAGEMENT CLIPS
-SLIDE EQUAL NUMBER OF WIRE MANAGERS (B)
INTO THE INSIDE OF EACH SUPPORT RAIL
SEE DETAIL B
C
D
1 1/2 FLAT MACHINE
BLACK CONNECTOR
BOLT
HEAD SCREW
SEE DETAIL A
ASSEMBLY INSTRUCTIONS
F
E
SPLINE
JOINT CONNECTOR
B1013-0004-00
PAGE 1
H
G
3/4" PAN
3/4" FLAT
HEAD SCREW
HEAD SCREW
DETAIL A
DETAIL B
J
THUMB SCREW
Advertisement
Table of Contents
Related Manuals for HBF Furniture LOGIC
Summary of Contents for HBF Furniture LOGIC
- Page 1 LOGIC CONFERENCE TABLE B1013-0004-00 PAGE 1 ASSEMBLY INSTRUCTIONS GENERAL NOTES 1. ALWAYS PROTECT THE WORKSURFACE DURING INSTALLATION. 2. ALWAYS LEVEL UNIT(S) AT FINAL LOCATION. 3. TWO PERSON ASSEMBLY REQUIRED HARDWARE 3/4" PAN WIRE MANAGER 1 1/2 FLAT MACHINE BLACK CONNECTOR...
- Page 2 LOGIC CONFERENCE TABLE B1013-0004-00 PAGE 2 3 ATTACH FLAT PLATES TO END OF RAILS -ALIGN FLAT PLATES WITH MOUNTING HOLES AS SEEN BELOW -SECURE PLATE TIGHTLY AGAINST END OF RAIL WITH FLAT HEAD 1 1/2" MACHINE SCREWS (C) -MAKE SURE TO PROPERLY ALIGN THE ALUMINUM EXTRUSIONS TO FULLY CLOSE GAPS...
- Page 3 LOGIC CONFERENCE TABLE B1013-0004-00 PAGE 3 6 ALIGN AND SECURE WORKSURFACE -INSTALL ONE JOINT CONNECTOR (F) ON EACH END OF JOINT TO ENSURE PROPER ALIGNMENT -INSTALL REMAINING JOINT CONNECTORS NOTE: ALWAYS INSTALL THE TOP RIGHT SIDE UP ON TOP OF THE BASES. USE SAWHORSES IF NECESSARY TO SUPPORT THE TOP BEFORE THE BASES ARE ATTACHED.
Need help?
Do you have a question about the LOGIC and is the answer not in the manual?
Questions and answers