Huawei SUN2000-3.8KTL-USL0 Quick Manual page 15

2. On the Operation console screen, choose Quick setting to perform quick setting.
•
Set the grid code applies to the country or region where the
SUN2000 is being used and the SUN2000 application scenario.
Before setting the grid code, ensure that the DC side of the
inverter is energized.
•
If the SUN2000 does not need to connect to the router, skip
Step 1 Set parameters for the Inverter to connect to the
router. If it does not need to connect to the management
system, skip Step 4 Set parameters for the Inverter to
connect to the management system.
•
After the management system is successfully connected, the
SUN2000 will report the SN and installer registration code. If
the connection fails, another connection attempt will start after
10 seconds. The installer registration code is generated by the
SUN2000 automatically and is used for the installer to register
with the management system and manage the inverter.
•
To add devices, tap Go to set after quick setting is complete,
and then configure parameters on the Add/Delete device
screen.
14