Automatic Exposure Adjustment - Sharp AL-1551 Operation Manual

AUTOMATIC EXPOSURE ADJUSTMENT

The automatic exposure level can be adjusted to suit your copying needs. This level is set for
copying from the original table and copying from the RSPF respectively.
When adjusting the automatic exposure level for copying from the RSPF, place an
1
original in the document feeder tray and make sure that the RSPF ( ) indicator lights
up.
When adjusting the level for copying from the original table, make sure that no original
is left in the document feeder tray.
Press the exposure mode selector key to select the photo (
2
Press and hold down the exposure mode selector key for approximately 5 seconds.
3
The photo (
two exposure indicators corresponding to the automatic exposure level which has
been selected will light up.
Press the light (
4
level as desired.
If exposure level 2 is selected, the two left-handmost indicators for that level will light
up simultaneously. Also, if level 4 is selected, the two right-handmost indicators for
that level will light up simultaneously.
Press the exposure selector key. The AUTO indicator will stop blinking and light up
5
steadily.
This automatic exposure level will remain in effect until you change it again by
this procedure.
) indicator will go out and the AUTO indicator will begin to blink. One or
) or dark ( ) key to lighten or darken the automatic exposure
) mode.
6
43