Table of Contents
Advertisement
Instruction
IMPORTANT! Depending on the stiffness of the membrane in the cartridges you are about to use,
you can choose to place the spring at the opposite side "2" of the machine or not use the spring at
all.
Different Cartridge brands have different stiffness of the membrane. Cartridges with a stiff
membrane sometimes makes it harder for the machine to start and needs to be accounted for when
deciding where to place the spring. If the spring is placed on the "2" side of the machine it will help
the forward motion and start the machine with ease even with very low voltage and long protrusion
of the needle. But if the cartridge membrane is soft or normal the spring is not needed.
The spring should only be located at the original "1" side when using Neo-cartridges.
If soft membrane cartridges are used: Don't use the spring at all.
If stiff membrane cartridges and low voltage are used and kick start is not available: Place the spring
at the "2" side.
InkMachines
Scorpion
Note! Be very careful when pressing down the spring not to bend it.
Rev 2.0 / 2018-09-24
5. Mount the Give adapter No. 148
(included in Conversion kit No. 110)
on the slide of the "2" side, make
sure the screw goes smooth into the
Give adapter, if not back the screw
out, align and try again so that the
thread is not damaged. Tighten
gently.
6. Remove the Stay up spring No. 24
placed on the side "1", by pressing
down the spring with the small flat
screwdriver. Put one corner of the
screwdriver between the fourth and
fifth coil and press the spring down
as straight as possible until it comes
clear and can be taken out.
7. Place the Stay up spring No. 24 in the hole
of the machine on the side you decide,
Put one corner of the screwdriver between
the fourth and fifth coil and press the spring
down as straight as possible until it comes
clear and can be inserted.
17 (29)
Advertisement
Table of Contents
