Additional Important Safeguards; Troubleshooting; For Technical Support - Shark S3305 Owner's Manual

ADDITIONAL IMPORTANT SAFEGUARDS

1. To avoid circuit overload, do not operate another appliance on the same electrical
outlet (circuit)
2. If an extension cord is absolutely necessary, a 15 ampere 14 gage cord should be
used. Cords rated for less amperage may overheat. Care should be taken to
arrange cord so that it cannot be pulled or tripped over.
3. Do not leave unattended when the system is connected to a power
supply/electrical outlet.
SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
WARNING:
This appliance is equipped with a
grounded-type 3-wire cord (3-prong
plug).
electrical outlet made for a 3-prong
plug. This is a safety feature. If the
plug should fail to fit the outlet, contact
an electrician to replace the outlet. Do
not attempt to defeat the safety purpose
of the grounding pin, part of the
3-prong plug.
This plug will only fit into an
2
TROUBLE SHOOTING
PROBLEM POSSIBLE CAUSE
1. Power cord not firmly
plugged into outlet.
STEAM MOP WILL
2. No power in wall outlet.
NOT OPERATE
3. Needs servicing.
STEAM MOP WILL
1. No water in water tank.
NOT MAKE STEAM
1. Micro-fiber cleaning cloth
STEAM MOP
is too wet.
LEAVES WATER
2. Unit is not level on the
ON THE FLOOR
floor.
1. Steam mop left in one
spot too long.
STEAM MOP LEFT
2. Steam mop not rested on
WHITE SPOT ON
floor protector pad.
FLOOR
3. Hard water.
TO ORDER REPLACEMNT MICRO-FIBER
CLOTHS
for Model S3305H
Call:1-866-98SHARK (1-866-987-4275)
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
visit our website: www.sharkvac.com

FOR TECHNICAL SUPPORT

for Model S3305H
Call.: 800-798-7398
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker.
Replace fuse/reset
breaker.
3. Call 1-800-798-7398.
1. Add water to the water
tank following instructions
on page 5.
1. Turn off unit, unplug from
power outlet and change
the micro-fiber cleaning
cloth.
2. Always keep the steam
mop level and parallel to
the floor.
1. Always place the steam
mop on the floor
protector pad when not in
use. To remove, use a
damp, dry cloth with a
few drops of white
vinegar and rub the stain
to remove.
2. Always place the steam
mop on the floor
protector pad when not in
use.
3. Use distilled water.
or
7